Browsing by Author "Wegener, Thomas"

Now showing 1 - 20 of 26

Consequences of Deep Rolling at Elevated Temperature on Near-Surface and Fatigue Properties of High-Manganese TWIP Steel X40MnCrAl19-2
(2021-11-05)
CuCrZr processed by laser powder bed fusion — Processability and influence of heat treatment on electrical conductivity, microstructure and mechanical properties
(2021-06-16)
Cyclic Deformation Response of Ultra-fine Grained Titanium at Elevated Temperatures
(2019)
Data‑driven prediction of the surface layer state in hard‑turning for optimization of component quality
(2024-01-30)
Effect of grain size on the very high cycle fatigue behavior and notch sensitivity of titanium
(2019)
Experimental Analysis of the Stability of Retained Austenite in a Low-Alloy 42CrSi Steel after Different Quenching and Partitioning Heat Treatments
(2023-06-21)
High-Throughput Alloy Development Using Advanced Characterization Techniques During Directed Energy Deposition Additive Manufacturing
(2023-03-31)
Impact of a single-side 100Cr6 clad layer on the tensile and fatigue properties of S550MC steel
(2024-08-01)
Influence of deep rolling at different temperatures on near-surface and mechanical properties of a Maraging C250 steel
(2024-04-27)
Influence of Surface Mechanical Attrition Treatment (SMAT) on Microstructure, Tensile and Low-Cycle Fatigue Behavior of Additively Manufactured Stainless Steel 316L
(2023-08-29)
Low-Cycle-Fatigue Performance of Stress-Aged EN AW-7075 Alloy
(2023-05-05)
Micromechanical Modeling of AlSi10Mg Processed by Laser-Based Additive Manufacturing: From as-Built to Heat-Treated Microstructures
(2022-08-13)
On the cyclic deformation behavior of wire-based directed energy deposited Fe-Ni Invar alloy
(Universität Kassel, 2024-10-18)
On the Evolution of Residual Stresses, Microstructure and Cyclic Performance of High-Manganese Austenitic TWIP-Steel after Deep Rolling
(2019-07-25)
On the fatigue behavior of a tool steel manufactured by powder bed based additive manufacturing—a comparison between electron- and laserbeam processed AISI H13
(2024-03-23)
On the Friction Stir Processing of Additive-Manufactured 316L Stainless Steel
(2022)
On the Impact of Texture and Grain Size on the Pseudoelastic Properties of Polycrystalline Fe–Ni–Co–Al–Ti Alloy
(2020-05-08)
On the influence of build orientation on properties of friction stir welded AleSi10Mg parts produced by selective laser melting
(2021-04-06)
On the influence of ϰ-carbides on the low-cycle fatigue behavior of high-Mn light-weight steels
(2021)
On the low-cycle fatigue behavior of thermo-mechanically processed high-strength aluminum alloys
(2021)