Suche
Anzeige der Dokumente 11-13 von 13
Aufsatz
Effect of Compositional Variation Induced by EBM Processing on Deformation Behavior and Phase Stability of Austenitic Cr-Mn-Ni TRIP Steel
(2020-01-24)
Electron beam melting (EBM) is an established powder bed-based additive manufacturing process for the fabrication of complex-shaped metallic components. For metastable austenitic Cr-Mn-Ni TRIP steel, the formation of a homogeneous fine-grained microstructure and outstanding damage tolerance have been reported. However, depending on the process parameters, a certain fraction of Mn evaporates. This can have a significant impact on deformation mechanisms as well as kinetics, as was previously shown for as-cast material. ...
Aufsatz
On the Impact of Texture and Grain Size on the Pseudoelastic Properties of Polycrystalline Fe–Ni–Co–Al–Ti Alloy
(2020-05-08)
The effects of thermomechanical treatments on crystallographic texture and grain size evolution and their impact on the pseudoelastic properties in Fe41–Ni28–Co17–Al11.5–Ti2.5 (at.%) were studied in the present paper. The results show that cold rolling leads to brass-type texture in this alloy, which is typical for low stacking fault energy materials. Thermal treatments up to 1300 °C were conducted and it is shown that the presence of β-phase helps to control grain growth. After the dissolution of the secondary phase ...
Buch
Optische Verformungsmessung an heterogenen Werkstoffsystemen
(kassel university press, 2020)
Im Rahmen der vorliegenden Arbeit wird die Anwendung der optischen Verformungsmessung auf heterogene Werkstoffsysteme untersucht, wobei dieses Verfahren auf unterschiedlichen Skalenebenen eingesetzt wird. Als erstes wird die digitale Bildkorrelation zur Temperaturüberwachung bei Hochtemperaturzugversuchen bis 350 °C an 0,6 mm dünnen lotplattierten Aluminiumprüfkörpern eingesetzt. Flächige Dehnungsauswertungen innerhalb des Prüfbereichs bestätigen die homogene Temperaturverteilung, wobei die Temperatur gleichzeitig ...