Suche
Anzeige der Dokumente 1-6 von 6
Konferenzveröffentlichung
A GaN-based DC/DC converter for e-vehicles applications
(IEEE, 2020)
This paper presents a 4 kW GaN-based galvanically isolated bidirectional DC/DC converter suitable for on-board auxiliary power supply systems, interconnecting the HV battery with the LV power system. To enable the trend towards higher levels of electrification, a second LV level of 48 V is introduced to supply the high-power consumers, relieving the 12 V grid on the one hand and/or avoiding using additional costly isolated converters connected to the HV batteries on the other. The built converter prototypes aim to ...
Konferenzveröffentlichung
Impact of implementation of auxiliary bias-windings on controllable inductors for power electronic converters
(IEEE, 2020)
Magnetic devices are an important part of electronic converters. They can be used to control some properties of the converters. There are three different control methods using an auxiliary bias-winding. In the presented paper, the impact of the implementation of the auxiliary bias-winding was studied for mixed biasing. Seven different designs were investigated in small signal measurements and 3D-FEM-simulations. The results were proven by calculated results of equivalent diagram circuits, which have been developed. ...
Konferenzveröffentlichung
Design of flexible pavements with cold recycled asphalt bases: Comparison of five national approaches
(2020)
The Application of reclaimed asphalt is becoming increasingly important in the European Road Network. Beside the conventional recycling options (i. e. hot asphalt mixtures), cold recycling has been successfully applied in numerous road structures within the secondary and the main road network. However, the standard design procedures for common pavement materials as well as the approaches for cold recycling differ from one country to another. The comparison of five national pavement design procedures shows, that ...
Konferenzveröffentlichung
Interleaved Buck Converter with Coupled Inductors as Auxiliary Bias-Current Source for Controllable Magnetic Devices
(VDE Verlag, 2020-08-26)
This paper presents an Interleaved Buck Converter with Coupled Inductors as a DC-Bias Current Source for Controllable Magnetic Devices, the modular interleaved Buck system supplies a low-ripple current for the auxiliary DC-bias winding of a controllable inductor with different biasing winding disposition in relationship with the main operating flux of the inductor. A 4-phase interleaved Buck converter system was built and inductance measurements where made for different operating current values of the DC-bias and the ...
Konferenzveröffentlichung
Methoden zur Beurteilung der statischen Brauchbarkeit von Tragwerken
(Institut für Baustatik und Baudynamik, Universität Stuttgart, 2020)
Fehler in der Tragwerksplanung können zu kinematischen (beweglichen) Tragwerken führen, die aus statischer Sicht unbrauchbar sind. Mit dem Ziel, den Statiker beim Auffinden und Beheben derartiger Fehler zu unterstützen, müssen spezielle Methoden entwickelt werden. Dieser Beitrag enthält einen Überblick über klassische und moderne Methoden. Dabei erfolgt eine Klassifizierung in indirekte, direkte, Ursachen-spezifische und akademische Methoden.
Konferenzveröffentlichung
Fast parallel quasi-static time series simulator for active distribution grid operation with pandapower
(IET, 2021)
The increasing penetration from intermittent renewable distributed energy resources in distribution grid brings along challenges in grid operation and planning. To evaluate the impact on the grid voltage profile, grid losses, and discrete actions from assets (e.g. transformer tap changes), quasi-static simulation is an appropriate method. Quasi-static time series and Monte-Carlo simulation requires a tremendous number of power flow calculations (PFCs), which can be significantly accelerated with a parallel High-Performance ...