Show simple item record

dc.date.accessioned2022-06-22T08:03:09Z
dc.date.available2022-06-22T08:03:09Z
dc.date.issued2012
dc.identifierdoi:10.17170/kobra-202206216370
dc.identifier.urihttp://hdl.handle.net/123456789/13938
dc.language.isoengeng
dc.publisherSociety of Plastics Engineers
dc.rightsNamensnennung 4.0 International*
dc.rights.urihttp://creativecommons.org/licenses/by/4.0/*
dc.subject.ddc660
dc.titlePull and Foam - Injection moulding method: Foamed ribs for stiffening plane componentseng
dc.typeKonferenzveröffentlichung
dcterms.abstractThe pull and foam method is a foam injection moulding method which is currently being developed at the Institut für Werkstofftechnik (IfW) (Institute of Materials Engineering) at the University of Kassel. The processing principle represents an alternative to the existing foam injection moulding special procedures and introduces the possibility to partially foam a component. In so doing, thin-walled, hardly foamed components with foamed ribs can be made in one processing step, thus also components with graded properties. Conventional foaming methods do not enable the manufacture of complex component geometries, wall thickness variations, and components with areas with varying degrees of foaming while maintaining a satisfactory surface quality. The pull and foam method offers possible solutions and makes it possible to attain locally targeted, customised mechanical properties. Therefore, it is possible to produce components with foamed areas that possess a high stiffness and compact areas with a high surface quality. In doing so, the method introduces the advantages of foam injection moulding procedure (lower clamping forces = smaller machines, material efficiency, lower melt viscosity, etc.) to new application fields, which were previously barred due to insufficient surface qualities or for constructive reasons.eng
dcterms.accessRightsopen access
dcterms.creatorHeim, Hans-Peter
dcterms.creatorTromm, Mike
dcterms.creatorJarka, Stefan
dcterms.creatorGövert, Stefan
dc.subject.swdSchaumkunststoffger
dc.subject.swdSpritzgießenger
dc.subject.swdMechanische Eigenschaftger
dc.subject.swdProzessentwicklung <Technik>ger
dc.type.versionpublishedVersion
dcterms.event.date2012-04-02
dcterms.event.placeOrlando
dcterms.source.collectionANTEC 2012 Plastics: Annual Technical Conference Proceedings, Orlando, Florida, USA, April 2-4, 2012.eng
dcterms.source.editorSociety of Plastics Engineers
dcterms.source.identifierisbn:978-0-9753707-0-4
dcterms.source.identifiereisbn:978-1-59124-732-6
dcterms.source.pageinfo2477-2480
kup.iskupfalse
dcterms.eventANTEC 2012


Files in this item

Thumbnail
Thumbnail

This item appears in the following Collection(s)

Show simple item record

Namensnennung 4.0 International
Except where otherwise noted, this item's license is described as Namensnennung 4.0 International