Suche
Anzeige der Dokumente 1-10 von 29
Dissertation

Fluoreszenzmikroskopische in-situ-Untersuchungen zu Wechselwirkungen von Fließmitteln und Partikeln in zementären Systemen
(2021)
Effektive rheologiemodifizierende Zusatzmittel sind aus der modernen Betontechnologie nicht mehr wegzudenken. Sei es der wirtschaftlichere, weil schnellere Einbau von fließfähigem Normalbeton oder die Herstellung von hoch- und ultrahochfesten Betonen; die so genannten Fließmittel spielen eine zentrale Rolle beim Einsatz und bei der Entwicklung zeitgemäßer, zementgebundener Baustoffe. Zur detaillierten Untersuchung der Wirkungsmechanismen wurde in dieser Arbeit eine Methode entwickelt, die die Beobachtung der ...
Aufsatz

Fluorescence Microscopic Investigations of the Retarding Effect of Superplasticizers in Cementitious Systems of UHPC
(2020-02-27)
The adsorption of superplasticizer molecules to particle surfaces in cementitious systems is a very important aspect for the desired liquefaction of pastes and concretes. This way, the comb shaped polymers shield attractive forces between the particles and induce a well-dispersed, homogeneous suspension. These admixtures allow the usage of fine fillers even in combination with low amounts of mixing water, and thus, are the basis for modern high performance concretes. However, the adsorption does not cause beneficial ...
Dissertation

Wechselwirkungen zwischen der Bitumenstruktur und Zusätzen bei Alterung
(2020)
Asphalt wird aus Gesteinskörnungen und Bitumen hergestellt. Dabei beeinflussen insbesondere die temperaturabhängigen visko-elastischen Bindemitteleigenschaften das Gebrauchsverhalten des Baustoffes und somit die Dauerhaftigkeit und Nutzungsdauer einer Asphaltstraße maßgeblich. Hierbei ist vor allem die Alterungsempfindlichkeit des Bitumens von großer Bedeutung. Bitumenalterung bewirkt eine Veränderung der chemischen und physikalischen Bitumeneigenschaften. Der mit der Bindemittelalterung einhergehende Verlust an ...
Dissertation
Zum Einfluss der Wechselwirkung zwischen Schalmaterial, Trennmittel und Beton auf die Eigenschaften von Sichtbetonflächen
(2018)
Sichtbetonflächen unterliegen hohen Anforderungen an das Erscheinungsbild. So soll die Farbgebung gleichmäßig und die Oberfläche porenarm sein - dabei variieren die Anfor-derungen mit der geforderten Sichtbetonklasse. Dies erfordert ein hohes Maß an Können bei der Herstellung sowie dezidierte Kenntnisse über Leistungsfähigkeit und Wechselwirkungen der eingesetzten Materialien. Die Erfahrungen aus der Praxis zeigen jedoch, dass die gezielte und gleichmäßige Herstellung von Sichtbetonflächen schwierig ist. Ziel dieser ...
Buch

Experimental Investigation on a Full-Scale Replica of the Closing Mechanism in Cheops’ Antechamber
(2020-07)
The 4th Dynasty Pyramids are an enduring technological enigma to most scholars. An important reason for this is a lack of necessary background: Most archeologists do not have the knowledge to develop solid technological solutions and most engineers don’t know the techno-archeological evidence, which is mostly unrecorded. Too often, this produced fantasy solutions lacking solid engineering proof of functionality, techno-archeological evidence, or both, with too many of them even accepted in scholarly circles. There ...
Dissertation
Virtual portfolios for earthquake insurance related risk simulations
(2018-04-05)
Seismic Risk, a combination of Hazard, Vulnerability and Loss, is becoming a mainstream topic due to an increase in the losses and damage caused by earthquake related effects worldwide.
Therefore, it has become an important aspect for insurer and reinsurers since it is extremely difficult to assess due to the lack of the necessary data compared, for example, to car insurance (chapter 1). As described in chapter 2, where the state of the art of seismic risk assessment and simulation is described alongside a more ...
Dissertation
Design procedure for shear panels and their connections in Hysteretic Device Systems
(2018-07)
Every year, earthquakes kill thousends of people and destroy or damage many buildings and structures worldwide. It was observed that the damages induced by earthquakes in developed countries (e.g., Japan and the USA) are less when compared to less developed countries such as Iran, Turkey or Pakistan. Comparing the earthquake damages indicated that even in new and modern buildings, some problems can be seen facing large earthquakes.
Every earthquake has proved the vulnerability of many structures to damages. A lot ...
Dissertation
Rissbildung und Zugtragverhalten von mit Stabstahl und Fasern bewehrtem Ultrahochfesten Beton (UHPC)
(Kassel Univ. Press, 2008)
Ultrahochfester Beton (UHPC) ist ein sehr gefügedichter zementgebundener Werkstoff, der
sich nicht nur durch eine hohe Druckfestigkeit, sondern auch durch einen hohen Widerstand
gegen jede Form physikalischen oder chemischen Angriffs auszeichnet.
Duktiles Nachbruchverhalten bei Druckversagen wird meist durch die Zugabe dünner kurzer
Fasern erreicht. In Kombination mit konventioneller Betonstahl- oder Spannbewehrung
ermöglicht UHPC die Ausführung sehr schlanker, weitgespannter Konstruktionen und eröffnet
zugleich ...
Dissertation
Behaviour Study of Grouted Connection for Offshore Wind Turbine Structures with Brittle Cement Based Grouts
(2020)
Researches show that the energy demand in the world is significantly increasing and climate change becomes a problematic issue, therefore, the interest in renewable energy is growing extremely fast. Offshore wind energy is one of the most effective renewable sources in Europe and other places in the world. One of the most important parts in the offshore foundation is the grouted connection as it is the first element to be designed in the design of the foundation structure of an offshore wind turbine because the ...
Dissertation
Large Numerical Models in Continuous Hybrid Simulation
(2016-10-20)
Hybrid simulation is a technique that combines experimental and numerical testing and has been used for the last decades in the fields of aerospace, civil and mechanical engineering. During this time, most of the research has focused on developing algorithms and the necessary technology, including but not limited to, error minimisation techniques, phase lag compensation and faster hydraulic cylinders. However, one of the main shortcomings in hybrid simulation that has pre- vented its widespread use is the size of the ...